Over time, plumbing in our homes is bound to fail. You can call a plumber to fix this, or you can try your hand at doing your own plumbing. Doing your own plumbing jobs is not always easy. The following article will contain helpful advice for anyone who wishes to do their own plumbing.
Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.
Make sure everyone that lives in your house knows where to find and use the main water shut off valve in case there is a burst pipe emergency. This is especially important if you live in an area where your pipes may freeze. Take a moment to show your family members where the valve is and how to properly shut it off.
When starting a plumbing project that is due to loud noises in your pipes empty the pipes first. This can be an easy fix to an other wise wasted huge job. Just close the main water line and open the facets throughout the house. After the water has stopped flowing turn the water on from the main source and check to see if the noise is eliminated.
Use strainers in all drains to catch hair and other objects. This will prevent all the material from going down the drain and causing a clog, which can cause a bigger problem down the line. Clean out the strainers daily so that you don’t start getting backup of water in your sink or tub.
It is not always necessary to call in a plumber when you have a damaged section of pipe in your plumbing. There are repair kits you can buy in your local hardware store which are excellent in repairing leaks. If you have a small leak, you can rub a compound stick over the hole or crack in the pipe to seal it shut. Epoxy paste is also an excellent remedy for a leaking pipes. Make sure you turn off the water and completely dry the pipe before applying the epoxy.
Always use cold water when your garbage disposal is running. The cold water will help keep the blades nice and sharp and will allow for a much smoother disposal. If you use hot water it will liquefy the grease, allowing it to accumulate in your drain causing your pipes to clog.
You should drain all of the water out of the tank of your hot water heater at least once every three to six months. Draining all of the water out of the tank helps to prevent sediment build-up at the bottom of the tank. This sediment can cause the tank to bang or to heat less efficiently.
In conclusion, plumbing is bound to fail over time. There are two solutions: call a plumber to fix it or attempt to fix it yourself. Doing the job by yourself can sometimes be hard, but if you remember the helpful advice from the article above, you can do the task.